WM8960 datasheet(53/92 Pages) WOLFSON

53 / 92 page

Production Data

WM8960

PD, August 2013, Rev 4.2

AUDIO INTERFACE OUTPUT TRISTATE

ADCLRC, DACLRC and BCLK to inputs. In Slave mode (MS=0) ADCLRC, DACLRC and BCLK are

by default configured as inputs and only ADCDAT will be tri-stated, (see Table 34).

When the ADCLRC/GPIO1 pin is configured as a GPIO, this pin will not be tristated by the TRIS

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R24 (18h)

Additional

Control (2)

TRIS

Tristates ADCDAT and switches ADCLRC,

DACLRC and BCLK to inputs.

0 = ADCDAT is an output; ADCLRC, DACLRC

and BCLK are inputs (slave mode) or outputs

(master mode)

1 = ADCDAT is tristated; DACLRC and BCLK

are inputs; ADCLRC is an input (when not

configured as a GPIO)

Table 34 Tri-stating the Audio Interface

MASTER MODE ADCLRC AND DACLRC ENABLE

In master mode, by default ADCLRC clock generator is disabled and will output a logic 0 when the

ADCs are both disabled and DACLRC clock generator is disabled and will output a logic 0 when the

DACs are both disabled.

clock generators are both disabled only when both ADCs and both DACs are disabled. This enables

the user to use e.g. ADCLRC for both ADC and DAC LRCLK and disable the ADC when DAC only

operation is required, (see Table 35).

When ADCLRC is configured as a GPIO (using ALRCGPIO), DACLRC is used for the ADCs and the

DACs and will only be disabled in master mode when both ADCs and both DACs are disabled.

Figure 33 Master Mode Clock Output Control

WM8960 데이터시트(PDF) 53 Page - Wolfson Microelectronics plc