| 전자부품 데이터시트 검색엔진 |
|
UM0501 데이터시트(PDF) 11 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
UM0501 데이터시트(HTML) 11 Page - STMicroelectronics |
|
11 / 19 page ![]() UM0501 Demonstration applications Doc ID 14320 Rev 3 15/23 2.10 BEEPER demo This mode demonstrates the 3 different frequencies that can be output on the BEEP pin. Prior to running the BEEPER demo, perform the following operations. ● Install the JP14 jumper in the top position (closer to the STM8S chip). ● Enable the beep output functionality by setting bit AFR7 of OPT2 option byte to ‘1’ (refer to the datasheets for details). When this mode is entered, the LSI clock is calibrated. The message shown in Figure 14 is displayed at the end of calibration. Figure 14. End of calibration message After a short time, another message shows the current output frequency. Press the KEY button repeatedly to change the frequency in this order. 1kHz 2kHz 4kHz 1-2-4 kHz OFF 1 kHz etc... The frequency selected is displayed on the LCD screen (see Figure 15) The LEDs also change depending on the selected frequency. Figure 15. Selecting the beep frequency UP: Press the joystick UP to exit the demo. KEY: Press the KEY button to change the beeper frequency. Calibration OK BEEPER 1kHz Press KEY |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |