RM0319 datasheet(184/368 Pages) STMICROELECTRONICS

184 / 368 page

MMC-SD card/SDIO controller

RM0319

184/368

Doc ID 022640 Rev 3

14.5.3

Issuing a command

Figure 60.

Command issue sequence

Check Command Inhibit (CMD) in the Present State register. Repeat this step until

Command Inhibit (CMD) is logic ‘0’.

If the Host Driver issues a SD Command with busy signal, go to step (3). If there is no

busy signal, go to step (5).

If the Host Driver issues an abort command, go to step (5). In the case of no abort

command, go to step (4).

Check Command Inhibit (DAT) in the Present State register. Repeat this step until

Command Inhibit (DAT) is set to logic ‘0’.

Set the value of the command argument to the Argument register.

Set the Command register.

Perform the Command Completion Sequence (see Section 14.5.4 below).

Start

End

(1)

(5)

Check Command

Inhibit (CMD)

CMD Line free

Issue the command

with the busy?

Yes

Issue Abort

Command?

Check Command

Inhibit(DAT)

DAT Lone used

DAT Lone free

New command can be issued

Set Argument Reg

Set Command Reg

Command Complete Sequence

CMD Line used

(2)

(3)

(4)

(6)

(7)

Yes

RM0319 데이터시트(PDF) 184 Page - STMicroelectronics

RM0319 데이터시트(HTML) 184 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL