UCS1002-2 datasheet(47/114 Pages) MICROCHIP

47 / 114 page

Programmable USB Port Power Controller with Charger Emulation

Datasheet

SMSC UCS1002

Revision 1.4 (07-16-13)

DATASHEET

Chapter 6 USB High-speed Data Switch

6.1

USB High-speed Data Switch

The UCS1002 contains a series USB 2.0 compliant high-speed switch between the DPIN and DMIN

pins and between the DPOUT and DMOUT pins. This switch is designed for high-speed, low latency

functionality to allow USB 2.0 full-speed and high-speed communications with minimal interference.

Nominally, the switch is closed in the Active state, allowing uninterrupted USB communications

between the upstream host and the portable device. The switch is opened when:

1. The UCS1002 is actively emulating using any of the charger emulation profiles except CDP (by

default - see Section 10.4.5, "High-speed Switch Configuration - 25h").

2. The UCS1002 is operating as a dedicated charger unless the HSW_DCE configuration bit is set

(see Section 10.4.5).

3. The UCS1002 is in the Detect state (by default) or in the Sleep state.

APPLICATION NOTE: If the VDD voltage is less than VDD_TH, the high-speed data switch will be disabled and

opened.

6.1.1

USB-IF High-speed Compliance

The USB data switch will not significantly degrade the signal integrity through the device DP / DM pins

with USB high-speed communications.

UCS1002-2 데이터시트(PDF) 47 Page - Microchip Technology