WTS701EMSLASHT datasheet(37/77 Pages) WINBOND

37 / 77 page

WTS701

Publication Release Date: May 2003

- 37 -

Revision 3.09

ABBR_DEL

DELETE ABBREVIATION ENTRY

This command deletes abbreviation entry from abbreviation table.

ABBR_DEL

Class

Type

Host controller

0x83

0x00

DATA0

…

DATAn

Byte

Sequence:

WTS701

Status Byte 0

Status Byte 1

Status Byte 0

…

Status Byte n%2

Description:

Delete an entry from the abbreviation table.

ENTER_RRSM SWAP MEMORY

This command is used in programming mode, and causes the xdata and code store memory to swap

spaces. Please refer to subsection 7.8 for more information about customizing abbreviations.

ENTER_RRSM

Class

Type

Host controller

0x0C

0x00

Byte Sequence:

WTS701

Status Byte 0

Status Byte 1

Description:

Swap memory between xdata and code store.

7.4.2 Illegal Commands

All commands described in section 7.4.1 are the only legal commands that should be sent to the

WTS701 device, unless stated otherwise. Other commands should not be sent to the device, as the

device behavior cannot be predicted. Specific illegal commands are those in which the 2 Most

Significant Bits of the Command Byte are zeros and are not defined in this document as commands

allowed to be sent to the WTS701.

7.4.3 Configuration Registers

The configuration registers are accessed by sending the appropriate configuration command followed

by a single byte of data to load the register. The definition of the contents of the various registers is

given below. The default value for each of these registers after Power Up or Reset is also described in

Table 10.

WTS701EM/T 데이터시트(PDF) 37 Page - Winbond

WTS701EM/T 데이터시트(HTML) 37 Page - Winbond

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77

데이터시트 다운로드

링크 URL