LIS2DH12 datasheet(17/53 Pages) STMICROELECTRONICS

17 / 53 page

DocID025056 Rev 6

17/53

LIS2DH12

Terminology and functionality

The turn-on time to transition to another operating mode is given in Table 11.

3.2.2

Self-test

The self-test allows the user to check the sensor functionality without moving it. When the

self-test is enabled, an actuation force is applied to the sensor, simulating a definite input

acceleration. In this case the sensor outputs will exhibit a change in their DC levels which

are related to the selected full scale through the device sensitivity. When the self-test is

activated, the device output level is given by the algebraic sum of the signals produced by

the acceleration acting on the sensor and by the electrostatic test-force. If the output signals

change within the amplitude specified inside Table 4, then the sensor is working properly

and the parameters of the interface chip are within the defined specifications.

Table 11. Turn-on time for operating mode transition

Operating mode change

Turn-on time

[ms]

12-bit mode to 8-bit mode

1/ODR

12-bit mode to 10-bit mode

1/ODR

10-bit mode to 8-bit mode

1/ODR

10-bit mode to 12-bit mode

7/ODR

8-bit mode to 10-bit mode

1/ODR

8-bit mode to 12-bit mode

7/ODR

Table 12. Current consumption of operating modes

Operating mode [Hz]

Low-power mode

(8-bit data output)

[μA]

Normal mode

(10-bit data output)

[μA]

High resolution

(12-bit data output)

[μA]

100

200

400

1344

185

1620

100

5376

185

LIS2DH12 데이터시트(PDF) 17 Page - STMicroelectronics

LIS2DH12 데이터시트(HTML) 17 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53

데이터시트 다운로드

링크 URL