LIS2DH12 datasheet(27/53 Pages) STMICROELECTRONICS

27 / 53 page

DocID025056 Rev 6

27/53

LIS2DH12

Digital interfaces

6.2

SPI bus interface

The LIS2DH12 SPI is a bus slave. The SPI allows writing to and reading from the registers

of the device.

The serial interface interacts with the application using 4 wires: CS, SPC, SDI and SDO.

Figure 6. Read and write protocol

CS is the serial port enable and it is controlled by the SPI master. It goes low at the start of

the transmission and goes back high at the end. SPC is the serial port clock and it is

controlled by the SPI master. It is stopped high when CS is high (no transmission). SDI and

SDO are respectively the serial port data input and output. These lines are driven at the

falling edge of SPC and should be captured at the rising edge of SPC.

Both the read register and write register commands are completed in 16 clock pulses or in

multiples of 8 in case of multiple read/write bytes. Bit duration is the time between two falling

edges of SPC. The first bit (bit 0) starts at the first falling edge of SPC after the falling edge

of CS while the last bit (bit 15, bit 23, ...) starts at the last falling edge of SPC just before the

rising edge of CS.

bit 0: RW bit. When 0, the data DI(7:0) is written into the device. When 1, the data DO(7:0)

from the device is read. In the latter case, the chip will drive SDO at the start of bit 8.

bit 1: MS bit. When 0, the address will remain unchanged in multiple read/write commands.

When 1, the address is auto incremented in multiple read/write commands.

bit 2-7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DI(7:0) (write mode). This is the data that is written into the device (MSb first).

bit 8-15: data DO(7:0) (read mode). This is the data that is read from the device (MSb first).

In multiple read/write commands further blocks of 8 clock periods will be added. When the

MS bit is ‘0’, the address used to read/write data remains the same for every block. When

the MS bit is ‘1’, the address used to read/write data is increased at every block.

The function and the behavior of SDI and SDO remain unchanged.

LIS2DH12 데이터시트(PDF) 27 Page - STMicroelectronics