STM32F302XD datasheet(23/168 Pages) STMICROELECTRONICS

23 / 168 page

DocID026900 Rev 4

23/168

STM32F302xD STM32F302xE

Functional overview

3.14.1

Temperature sensor

The temperature sensor (TS) generates a voltage VSENSE that varies linearly with

temperature.

The temperature sensor is internally connected to the ADC1_IN16 input channel which is

used to convert the sensor output voltage into a digital value.

The sensor provides good linearity but it has to be calibrated to obtain good overall

accuracy of the temperature measurement. As the offset of the temperature sensor varies

from chip to chip due to process variation, the uncalibrated internal temperature sensor is

suitable for applications that detect temperature changes only.

To improve the accuracy of the temperature sensor measurement, each device is

individually factory-calibrated by ST. The temperature sensor factory calibration data are

stored by ST in the system memory area, accessible in read-only mode.

3.14.2

Internal voltage reference (VREFINT)

The internal voltage reference (VREFINT) provides a stable (bandgap) voltage output for the

ADC and Comparators. VREFINT is internally connected to the ADCx_IN18, x=1...4 input

channel. The precise voltage of VREFINT is individually measured for each part by ST during

production test and stored in the system memory area. It is accessible in read-only mode.

3.14.3

VBAT battery voltage monitoring

This embedded hardware feature allows the application to measure the VBAT battery voltage

using the internal ADC channel ADC1_IN17. As the VBAT voltage may be higher than VDDA,

and thus outside the ADC input range, the VBAT pin is internally connected to a bridge

divider by 2. As a consequence, the converted digital value is half the VBAT voltage.

3.14.4

OPAMP reference voltage (VREFOPAMP)

Every OPAMP reference voltage can be measured using a corresponding ADC internal

channel: VREFO, VREFOPAMP1 connected to ADC1 channel 15, VREFOPAMP2

connected to ADC2 channel 17.

3.15

Digital-to-analog converter (DAC)

One 12-bit buffered DAC channel can be used to convert digital signals into analog voltage

signal outputs. The chosen design structure is composed of integrated resistor strings and

an amplifier in inverting configuration.

This digital interface supports the following features:

•

One DAC output channel

•

8-bit or 10-bit monotonic output

•

Left or right data alignment in 12-bit mode

•

Synchronized update capability

•

Noise-wave generation

•

Triangular-wave generation

•

DMA capability (for each channel)

STM32F302XD 데이터시트(PDF) 23 Page - STMicroelectronics

STM32F302XD 데이터시트(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL