PCF8813 datasheet(23/72 Pages) PHILIPS

23 / 72 page

2004 Mar 05

Philips Semiconductors

Product speciﬁcation

(67 + 1)

× 102 pixels matrix LCD driver

PCF8813

10 I2C-BUS INTERFACE (Hs-MODE)

10.1

Characteristics of the I2C-bus (Hs-mode)

The I2C-bus Hs-mode is for bidirectional, two-line

communication between different ICs or modules with

speeds up to 3.4 MHz. The only difference between

Hs-mode slave devices and Fast-mode slave devices is

the speed at which they operate, therefore the buffers on

the SLCH and SDAH outputs(1) have an open-drain. This

is the same for I2C-bus master devices which have an

open-drain SDAH output and a combination of open-drain

pull-down and current source pull-up circuits on the SCLH

output. Only the current source of one master is enabled

at any one time, and only during Hs-mode. Both lines must

be connected to a positive supply via a pull-up resistor.

Data transfer may be initiated only when the bus is not

busy.

10.1.1

SYSTEM CONFIGURATION

• Transmitter: the device that sends the data to the bus

• Receiver: the device that receives the data from the bus

• Master: the device which initiates a transfer, generates

clock signals and terminates a transfer

• Slave: the device addressed by a master

• Multi-master: more than one master can attempt to

control the bus at the same time without corrupting the

message

• Arbitration: procedure to ensure that, if more than one

master simultaneously tries to control the bus, only one

is allowed to do so and the message is not corrupted

• Synchronisation: procedure to synchronize the clock

signals of two or more devices.

(1) In Hs-mode, SCL and SDA lines operating at the higher

frequency are referred to as SCLH and SDAH.

MGA807

SDA

SCL

MASTER

TRANSMITTER/

RECEIVER

MASTER

TRANSMITTER

SLAVE

TRANSMITTER/

RECEIVER

SLAVE

RECEIVER

MASTER

TRANSMITTER/

RECEIVER

Fig.25 System configuration.

10.1.2

BIT TRANSFER

One data bit is transferred during each clock pulse (see

Fig.26). The data on the SDAH line must remain stable

during the HIGH period of the clock pulse as changes in

the data line at this time will be interpreted as control

signals.

handbook, full pagewidth

MBC621

data line

stable;

data valid

change

of data

allowed

SDA

SCL

Fig.26 Bit transfer.

PCF8813 데이터시트(PDF) 23 Page - NXP Semiconductors

PCF8813 데이터시트(HTML) 23 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

데이터시트 다운로드

링크 URL