LSM9DS1TR datasheet(45/72 Pages) STMICROELECTRONICS

45 / 72 page

DocID025715 Rev 3

45/72

LSM9DS1

Accelerometer and gyroscope register description

7.11

WHO_AM_I (0Fh)

Who_AM_I register.

7.12

CTRL_REG1_G (10h)

Angular rate sensor Control Register 1.

Table 44. CTRL_REG1_G register

Table 45. CTRL_REG1_G register description

ODR_G [2:0] are used to set ODR selection when both the accelerometer and gyroscope

are activated. BW_G [1:0] are used to set gyroscope bandwidth selection.

The following table summarizes all frequencies available for each combination of the

ODR_G / BW_G bits after LPF1 (see Table 46) and LPF2 (see Table 47) when both the

accelerometer and gyroscope are activated. For more details regarding signal processing

please refer to Figure 28.

Table 43. WHO_AM_I register

101

ODR_G2

ODR_G1

ODR_G0

FS_G1

FS_G0

0(1)

1. This bit must be set to ‘0’ for the correct operation of the device.

BW_G1

BW_G0

ODR_G [2:0]

Gyroscope output data rate selection. Default value: 000

(Refer to Table 46 and Table 47)

FS_G [1:0]

Gyroscope full-scale selection. Default value: 00

(00: 245 dps; 01: 500 dps; 10: Not Available; 11: 2000 dps)

BW_G [1:0]

Gyroscope bandwidth selection. Default value: 00

Table 46. ODR and BW configuration setting (after LPF1)

ODR_G2

ODR_G1

ODR_G0

ODR [Hz]

Cutoff [Hz](1)

1. Values in the table are indicative and can vary proportionally with the specific ODR value.

Power-down

n.a.

14.9

59.5

119

238

476

100

952

100

n.a.

LSM9DS1TR 데이터시트(PDF) 45 Page - STMicroelectronics

LSM9DS1TR 데이터시트(HTML) 45 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72

데이터시트 다운로드

링크 URL