ATXMEGA8E5 datasheet(20/153 Pages) MICROCHIP

20 / 153 page

 2018 Microchip Technology Inc.

Data Sheet Complete

DS40002059A-page 20

ATxmega32E5/16E5/8E5

8.5

Data Memory

The data memory contains the I/O memory, internal SRAM and EEPROM. The data memory is organized as one continu-

ous memory section, see Table 8-2 on page 21. To simplify development, I/O Memory, EEPROM and SRAM will always

have the same start addresses for all XMEGA devices.

Figure 8-2.

Data Memory Map (hexadecimal value)

8.6

EEPROM

AVR XMEGA E5 devices have EEPROM for nonvolatile data storage. It is memory mapped and accessed in normal data

space. The EEPROM supports both byte and page access. EEPROM allows highly efficient EEPROM reading and

EEPROM buffer loading. When doing this, EEPROM is accessible using load and store instructions. EEPROM will always

start at hexadecimal address 0x1000.

8.7

I/O Memory

The status and configuration registers for peripherals and modules, including the CPU, are addressable through I/O mem-

ory locations. All I/O locations can be accessed by the load (LD/LDS/LDD) and store (ST/STS/STD) instructions, which are

used to transfer data between the 32 registers in the register file and the I/O memory. The IN and OUT instructions can

address I/O memory locations in the range of 0x00 to 0x3F directly. In the address range 0x00 - 0x1F, single-cycle instruc-

tions for manipulation and checking of individual bits are available.

The I/O memory address for all peripherals and modules in XMEGA E5 is shown in the “Peripheral Module Address Map”

on page 68.

8.7.1

General Purpose I/O Registers

The lowest four I/O memory addresses are reserved as general purpose I/O registers. These registers can be used for

storing global variables and flags, as they are directly bit-accessible using the SBI, CBI, SBIS, and SBIC instructions.

8.8

Data Memory and Bus Arbitration

Since the data memory is organized as three separate sets of memories, the different bus masters (CPU, EDMA controller

read and EDMA controller write, etc.) can access different memory sections at the same time.

8.9

Memory Timing

Read and write access to the I/O memory takes one CPU clock cycle. A write to SRAM takes one cycle, and a read from

SRAM takes two cycles. For burst read (EDMA), new data are available every cycle. EEPROM page load (write) takes one

cycle, and three cycles are required for read. For burst read, new data are available every second cycle. Refer to the

instruction summary for more details on instructions and instruction timing.

Byte Address

ATxmega32E5

Byte Address

ATxmega16E5

Byte Address

ATxmega8E5

I/O Registers (4K)

FFF

1000

EEPROM (1K)

1000

EEPROM (512B)

1000

EEPROM (512B)

13FF

11FF

RESERVED

2000

Internal SRAM (4K)

2000

Internal SRAM (2K)

2000

Internal SRAM (2K)

2FFF

27FF

ATXMEGA8E5 데이터시트(PDF) 20 Page - Microchip Technology

ATXMEGA8E5 데이터시트(HTML) 20 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL