T1X06000GA-N1-R3 datasheet(101/118 Pages) TOSHIBA

101 / 118 page

E-3

T1000 Series UPS 5.6-6kVA Installation and Operation Manual – 91074-005

4. CASTER INSTALLATION

1. Lay each module on it’s side so that the display/Name panel is on the right side as you face the front

of the module. Position the module so you’re facing the bottom of the unit. (Figure 3)

2. Locate the three caster mounting holes on the left side, and four mounting holes on the right side of

the module. (Figure 3)

3. Secure one caster assembly to the rear base of the module using three (3) 10-32 x 1/2 Philips

Screws. (Figure 4)

4. Secure the remaining caster assembly to the front base of the module using four (4) 10-32 x 1/2 Phil-

ips Screws. (Figure 4)

5. Repeat steps 7-10 for each module in the system.

6. Set the module(s) upright on the casters.

7. Position the module(s) near their final installation location.

NOTE: The casters roll in a straight line, but do not swivel. To turn the module, slide the front

or back end laterally to change direction.

8. Facing the front of the modules, arrange the modules left to right in the following order:

•

Transformer Module (if available)

•

Power Module

•

Battery Module with output panel(if available)

•

Second Battery Module without output panel (if available)

4 Caster Assy

mounting

screw holes

3 Caster Assy

mounting

screw holes

FIGURE 3: POSITION MODULE FOR CASTER INSTALLATION

Screw Caster Assy to

Rear of T1000 Module

Screw Caster Assy to

Front of T1000 Module

FIGURE 4: ATTACH CASTER ASSEMBLIES

T1X06000GA-N1-R3 데이터시트(PDF) 101 Page - Toshiba Semiconductor