AT90PWM2 datasheet(85/365 Pages) ATMEL

85 / 365 page

AT90PWM2/3

4317B–AVR–02/05

the edge detector uses sampling, the maximum frequency of an external clock it can

detect is half the sampling frequency (Nyquist sampling theorem). However, due to vari-

ation of the system clock frequency and duty cycle caused by Oscillator source (crystal,

resonator, and capacitors) tolerances, it is recommended that maximum frequency of an

external clock source is less than f

clk_I/O/2.5.

An external clock source can not be prescaled.

Figure 30. Prescaler for Timer/Counter0 and Timer/Counter1(1)

Note:

1. The synchronization logic on the input pins (

Tn/T0) is shown in Figure 29.

General Timer/Counter

Control Register – GTCCR

• Bit 7 – TSM: Timer/Counter Synchronization Mode

Writing the TSM bit to one activates the Timer/Counter Synchronization mode. In this

mode, the value that is written to the PSRSYNC bit is kept, hence keeping the corre-

sponding prescaler reset signals asserted. This ensures that the corresponding

Timer/Counters are halted and can be configured to the same value without the risk of

one of them advancing during configuration. When the TSM bit is written to zero, the

PSRSYNC bit is cleared by hardware, and the Timer/Counters start counting

simultaneously.

PSRSYNC

Clear

clk

I/O

Synchronization

Bit

TSM

ICPSEL1

–

PSRSYNC

GTCCR

Read/Write

R/W

Initial Value

AT90PWM2 데이터시트(PDF) 85 Page - ATMEL Corporation