WM8581 datasheet(22/94 Pages) WOLFSON

22 / 94 page

WM8581

Product Preview

PP Rev 1.0 March 2006

SOFTWARE REGISTER RESET

Writing to register R53 will cause a register reset, resetting all register bits to their default values.

Note that the WM8581 is powered down by default so writing to this register will power down the

device.

Table 11 Software Reset

DIGITAL AUDIO INTERFACES

Audio data is transferred to and from the WM8581 via the Digital Audio Interfaces. There are two Receive

Audio Interfaces and two Transmit Audio Interfaces. The Digital Routing options for these interfaces are

described on page 24. Control of the audio interfaces is described below.

MASTER AND SLAVE MODES

The Audio Interfaces require both a left-right-clock (LRCLK) and a bit-clock (BCLK). These can be supplied

externally (slave mode) or they can be generated internally (master mode). When in master mode, the

BCLKs and LRCLKs for an interface are output on the corresponding BCLK and LRCLK pins. By default, all

interfaces operate in slave mode, but can operate in master mode by setting the PAIFTXMS, PAIFRXMS,

SAIFMS register bits. In Hardware Control Mode, the PAIF Transmitter can operate in master mode by

setting the SDI pin.

Figure 12 Slave Mode

Figure 13 Master Mode

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R53

RESET

35h

8:0

RESET

n/a

Writing any data value to this register

will apply a reset to the device

registers.

WM8581 데이터시트(PDF) 22 Page - Wolfson Microelectronics plc