MC68340 datasheet(301/441 Pages) FREESCALE

301 / 441 page

7- 6

MC68340 USER’S MANUAL

MOTOROLA

7.2.3 External Input (SCLK)

This input can be used as the clock input for channel A and/or channel B and is

programmable in the clock-select registers (CSR). When used as the receiver clock,

received data is sampled on the rising edge of the clock. When used as the transmitter

clock, data is output on the falling edge of the clock. If this input is not used, it must be

connected to VCC or GND.

7.2.4 Channel A Transmitter Serial Data Output (TxDA)

This signal is the transmitter serial data output for channel A. The output is held high

('mark' condition) when the transmitter is disabled, idle, or operating in the local loopback

mode. Data is shifted out on this signal on the falling edge of the clock source, with the

least significant bit transmitted first.

7.2.5 Channel A Receiver Serial Data Input (RxDA)

This signal is the receiver serial data input for channel A. Data received on this signal is

sampled on the rising edge of the clock source, with the least significant bit received first.

7.2.6 Channel B Transmitter Serial Data Output (TxDB)

This signal is the transmitter serial data output for channel B. The output is held high

('mark' condition) when the transmitter is disabled, idle, or operating in the local loopback

mode. Data is shifted out on this signal at the falling edge of the clock source, with the

least significant bit transmitted first.

7.2.7 Channel B Receiver Serial Data Input (RxDB)

This signal is the receiver serial data input for channel B. Data on this signal is sampled

on the rising edge of the clock source, with the least significant bit received first.

7.2.8 Channel A Request-To-Send (

RTSA)

This active-low output signal is programmable as the channel A request-to-send or as a

dedicated parallel output.

7.2.8.1

RTSA. When used for this function, this signal can be programmed to be

automatically negated and asserted by either the receiver or transmitter. When connected

to the clear-to-send (

CTS

≈) input of a transmitter, this signal can be used to control serial

data flow.

7.2.8.2 OP0. When used for this function, this output is controlled by bit 0 in the output

port data register (OP).

7.2.9 Channel B Request-To-Send (

RTSB)

This active-low output signal is programmable as the channel B request-to-send or as a

dedicated parallel output.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MC68340 데이터시트(PDF) 301 Page - Freescale Semiconductor, Inc

MC68340 데이터시트(HTML) 301 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL