MC68340 datasheet(64/441 Pages) FREESCALE

64 / 441 page

MOTOROLA

MC68340 USER’S MANUAL

3- 15

If a system asserts

DSACK

≈ for the required window around the falling edge of S2 and

obeys the proper bus protocol by maintaining

DSACK

≈ (and/or BERR/HALT) until and

throughout the clock edge that negates

AS (with the appropriate asynchronous input hold

time), no wait states are inserted. The bus cycle runs at its maximum speed for bus cycles

terminated with

DSACK

≈ (three clocks per cycle). When BERR (or BERR and HALT) is

asserted after

DSACK

≈, BERR (and HALT) must meet the appropriate setup time prior to

the falling clock edge one clock cycle after

DSACK

≈ is recognized. This setup time is

critical, and the MC68340 may exhibit erratic behavior if it is violated. When operating

synchronously, the data-in setup and hold times for synchronous cycles may be used

instead of the timing requirements for data relative to

DS.

3.2.6 Fast Termination Cycles

With an external device that has a fast access time, the chip select circuit fast termination

enable (FTE) can provide a two-clock external bus transfer. Since the chip select circuits

are driven from the system clock, the bus cycle termination is inherently synchronized with

the system clock. Refer to Section 4 System Integration Module for more information on

chip selects.When fast termination is selected, the DD bits of the corresponding address

mask register are overridden. Fast termination can only be used with zero wait states. To

use the fast termination option, an external device should be fast enough to have data

ready, within the specified setup time, by the falling edge of S4. Figure 3-6 shows the

DSACK

≈ timing for a read with two wait states, followed by a fast termination read and

write. When using the fast termination option,

DS is asserted only in a read cycle, not in a

write cycle.

CLKOUT

R/W

DSACKx

D15–D0

FAST

TERMINATION

READ

TWO WAIT STATES IN READ

* DSACKx only internally asserted for fast termination cycles.

FAST

TERMINATION

WRITE

Figure 3-6. Fast Termination Timing

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MC68340 데이터시트(PDF) 64 Page - Freescale Semiconductor, Inc

MC68340 데이터시트(HTML) 64 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL