TMPR4925 datasheet(80/590 Pages) TOSHIBA

80 / 590 page

Chapter 4 Address Mapping

4-2

4.2

4.2.1

Addressing

TX4925 internal registers are to be accessed through 64 K bytes address space that is based on

physical address 0xFF1F_0000 or pointed address by RAMP register (refer to 5.2.11). Figure 4.2.1

shows how to generate internal register address. Physical address 1 and physical address 2 shown

Figure 4.2.1 access the same register.

In TX49/H2 Core, the physical address form 0xFF00_0000 to 0xFF3F_FFFF are unchached mapped

to the virtual address form 0xFF00_0000 to 0xFF3F_FFFF.

This space includes the region form 0xFF1F_0000 allocated TX4925 internal registers at

initialization.

Figure 4.2.1 Generating Physical Address for a Internal Register

4.2.2

Ways to Access to Internal Registers

2 ways to access to the internal registers of TX4925 are supported. First is 32-bit register access.

Second is PCI configuration register access in PCI satellite mode.

32-bit register supports 32-bit size access only. Another size access without 32-bit size is undefined.

When the build-in PCI controller works in the satellite mode (refer to “10.3.1 Terminology

Explanation”), PCI configuration registers are to be accessed through PCI bus in configuration cycles. It

is possible to access to the arbitrary size of PCI configuration register as always Little Endian space

regardless the system setup.

Base Address

(0xFF1F_0000)

Offset Address

Physical Address 1

Base Address Register

(RAMP)

Offset Address

Physical Address 2

(Initial Value = 0xFF1F_0000)

TMPR4925 데이터시트(PDF) 80 Page - Toshiba Semiconductor