| 전자부품 데이터시트 검색엔진 |
|
TMPR4925 데이터시트(PDF) 116 Page - Toshiba Semiconductor |
|
|
|||||||||||||||||||||||||||||
TMPR4925 데이터시트(HTML) 116 Page - Toshiba Semiconductor |
|
116 / 590 page ![]() Chapter 7 External Bus Controller 7-6 7.3.4 External Address Output The maximum memory space size for each channel is 1 GB (230B). Addresses are output by dividing the 20-bit ADDR[19:0] signal into two parts: the upper address and the lower address. The address bit output to each bit of the ADDR[19:0] signal changes according to the setting of the channel data bus width. (See “7.3.5 Data Bus Size” for more information.) It is possible for an external device to latch the upper eight address bits using the UAE signal. Either the UAE signal itself can be used as a Latch Enable signal or the upper address can be latched at the rise of SYSCLK when the UAE signal is being asserted. The ADDR signal output is held for one clock cycle after the UAE signal assertion when the CCFG.UAEHOLD bit is set (default). (See Figure 7.5.1.) The ADDR signal output is not held when the CCFG.UAEHOLD bit is cleared. This hold time setting is applied globally to all channels. The UAE signal of the upper address is always asserted at the first external bus access cycle after Reset. In all subsequent external bus access cycles, the bit mapping of the upper address output to ADDR[19:12] is compared to the bit mapping of the upper address output to ADDR[19:12] previously. The upper address is output and the UAE signal is asserted only if the compared results do not match. As indicated below in Table 7.3.3, in the case of channel sizes that do not use the upper address latched by the UAE signal, with the exception of the first cycle after reset, the upper address is not output and the UAE signal is not asserted. Table 7.3.3 Relationship Between the Upper Address Output and the Channel Size (CS) CS Bus Width 1 MB 2 MB 4 MB 8 MB or more 32 bits √ 16 bits √ √ 8 bits √ √ √ √: The upper address output changes when the upper address changes. : The upper address output does not change (with the exception of the first cycle after reset.) |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |