TSS461C datasheet(21/57 Pages) ATMEL

21 / 57 page

TSS461C

4193G–AUTO–12/04

If there are less than four edges during one SDC period, the diagnosis mode will

change to the major error mode.

•

Transmission diagnosis:

The transmission compares RxD1 and RxD2 inputs (through the input comparators

and the filters) with the data transmitted on TxD output.

At a time when the transmission logic generates a dominant (recessive transition),

the inputs can give different values. Taking into account the filtering delay, the bus

line seen as dominant is assumed to be correct, the other one, recessive, is

considered faulty. The diagnosis mode is changed to reflect that.

•

Protocol fault:

The protocol fault is detected by counting the number of consecutive dominant

timeslots.

If eight consecutive timeslots are dominant, the diagnosis mode will change to the

major error mode.

Generation of Internal

Signals

RI Signal (Return to Idle)

This signal is used to return to nominal mode in the three specified selection modes (see

Section “Diagnosis States” and Section “Programming Modes”). The RI signal is dis-

abled in automatic selection mode.

The RI signal is a pulse generated when an EOF is detected. So, at the end of each

frame, regarding the diagnosis status bit Sa, Sb & Sc, the user can select its own

choice.

SDC Signal (Synchronous

Diagnosis Clock)

This time base is used by diagnosis system in automatic selection mode (see

Section “Programming Modes”) when no event is recorded on the bus.

The SDC is generated either by a special SDC divider connected to the timeslot clock,

or manually. The SDC clock period must be longer compared to the timeslot duration.

A typical SDC period should be greater than the maximum frame length appearing on

the VAN network.

TIP Signal (Transmission in

Progress)

This signal must be enabled to allow the transmission diagnosis (see Section “Transition

Analyses”).

The TIP turns on synchronously at the beginning of the transmission:

•

For asynchronous bus access, the beginning of SOF;

•

For synchronous bus access, the beginning of the identifier field; and

•

For a request of in frame reply, the RTR bit of the command field.

The TIP turns off synchronously at the end of the transmission:

•after EOF;

•

after a losing of arbitration or a code violation detection; and

•

for a requester of in frame reply, when the arbitration is lost on RTR the bit.

This signal is not generated when the transmission logic only sends an ACK.

TSS461C 데이터시트(PDF) 21 Page - ATMEL Corporation

TSS461C 데이터시트(HTML) 21 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

데이터시트 다운로드

링크 URL