TSS461C datasheet(27/57 Pages) ATMEL

27 / 57 page

TSS461C

4193G–AUTO–12/04

•

The Transmission In Progress (TIP) tells the diagnostic system to enable

transmission diagnosis.

ESDC: Enable System

Diagnosis Clock

One: Enable SDC divider.

Zero: Disable SDC divider.

•

The Synchronous Diagnosis Clock (SDC) controls the cycle time of the

synchronous diagnosis.

Command Register (0x03)

•

Write only register.

•

Reserved: Bit 1, 2. These bits cannot be set by the user; a zero must always be

written to these bit.

•

If the circuit is operating at low bit rates, there might be a considerable delay

between the writing of this register and the performing of the actual command (worst

case 6 timeslots). The user must verify, by reading the Line Status Register (0x04),

that the commands have been performed.

GRES: General Reset

The Reset circuit command bit performs, if set, exactly as if the external reset pin was

asserted. This command bit has its own auto-reset circuitry.

One: Reset active

Zero: Reset inactive

SLEEP: Sleep Command

If the user sets the Sleep bit, the circuit will enter sleep mode. When the circuit

sleep mode, all non-user registers are setup to minimize power consumption and the

oscillator is stopped. To exit from this mode, the user must set either the idle or activate

commands.

One: Sleep active

Zero: Sleep inactive

7654321

GRES

SLEEP

IDLE

ACTI

REAR

MSDC

TSS461C 데이터시트(PDF) 27 Page - ATMEL Corporation

TSS461C 데이터시트(HTML) 27 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

데이터시트 다운로드

링크 URL