전자부품 데이터시트 검색엔진
  Korean  ▼
ALLDATASHEET.CO.KR

X  

CLRC663 데이터시트(PDF) 14 Page - NXP Semiconductors

부품명 CLRC663
상세설명  High performance multi-protocol NFC frontend CLRC663 and CLRC663 plus
PDF  177 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
제조업체  NXP [NXP Semiconductors]
홈페이지  http://www.nxp.com
Logo NXP - NXP Semiconductors

CLRC663 데이터시트(HTML) 14 Page - NXP Semiconductors

Back Button CLRC663 Datasheet HTML 10Page - NXP Semiconductors CLRC663 Datasheet HTML 11Page - NXP Semiconductors CLRC663 Datasheet HTML 12Page - NXP Semiconductors CLRC663 Datasheet HTML 13Page - NXP Semiconductors CLRC663 Datasheet HTML 14Page - NXP Semiconductors CLRC663 Datasheet HTML 15Page - NXP Semiconductors CLRC663 Datasheet HTML 16Page - NXP Semiconductors CLRC663 Datasheet HTML 17Page - NXP Semiconductors CLRC663 Datasheet HTML 18Page - NXP Semiconductors Next Button
Zoom Inzoom in Zoom Outzoom out
 14 / 177 page
background image
NXP Semiconductors
CLRC663
High performance multi-protocol NFC frontend CLRC663 and CLRC663 plus
8.2.1 Timer modes
8.2.1.1 Time-Out- and Watch-Dog-Counter
Having configured the timer by setting register T(x)ReloadValue and starting the counting of Timer(x) by setting
bit TControl.T(x)StartStop and TControl.T(x)Running, the timer unit decrements the T(x)CounterValue Register
beginning with the configured start event. If the configured stop event occurs before the Timer(x) underflows
(e.g. a bit is received from the card), the timer unit stops (no interrupt is generated).
If no stop event occurs, the timer unit continues to decrement the counter registers until the content is zero and
generates a timer interrupt request at the next clock cycle. This allows indicating to a host that the event did not
occur during the configured time interval.
8.2.1.2 Wake-up timer
The wake-up Timer4 allows to wake-up the system from standby after a predefined time. The system can be
configured in such a way that it is entering the standby mode again in case no card had been detected.
This functionality can be used to implement a low-power card detection (LPCD). For the low-power card
detection, it is recommended to set T4Control.T4AutoWakeUp and T4Control.T4AutoRestart, to activate
the Timer4 and automatically set the system in standby. The internal low frequency oscillator (LFO) is
then used as input clock for this Timer4. If a card is detected, the host-communication can be started. If bit
T4Control.T4AutoWakeUp is not set, the CLRC663 will not enter the standby mode again in case no card is
detected but stays fully powered.
8.2.1.3 Stop watch
The elapsed time between a configured start- and stop event may be measured by the CLRC663 timer unit. By
setting the registers T(x)ReloadValueHi, T(x)ReloadValueLo the timer starts to decrement as soon as activated.
If the configured stop event occurs, the timer stops decrementing. The elapsed time between start and stop
event can then be calculated by the host dependent on the timer interval TTimer:
(1)
If an underflow occurred which can be identified by evaluating the corresponding IRQ bit, the performed time
measurement according to the formula above is not correct.
8.2.1.4 Programmable one-shot timer
The host configures the interrupt and the timer, starts the timer and waits for the interrupt event on pin IRQ.
After the configured time, the interrupt request will be raised.
8.2.1.5 Periodical trigger
If the bit T(x)Control.T(x)AutoRestart is set and the interrupt is activated, an interrupt request will be indicated
periodically after every elapsed timer period.
8.3 Contactless interface unit
The contactless interface unit of the CLRC663 supports the following read/write operating modes:
• ISO/IEC14443 type A and MIFARE Classic
• ISO/IEC14443B
CLRC663
All information provided in this document is subject to legal disclaimers.
© 2024 NXP B.V. All rights reserved.
Product data sheet
Rev. 5.3 — 3 January 2024
14 / 177



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100  ...More


데이터시트 다운로드

Go To PDF Page


링크 URL



ALLDATASHEET 가 귀하에 도움이 되셨나요?  [ DONATE ] 

Alldatasheet는?   |   광고문의   |   운영자에게 연락하기   |   개인정보취급방침   |   링크 투 데이터시트    |   링크교환   |   제조사별 검색
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com