CLRC63201TSLASH0FE datasheet(127/163 Pages) PHILIPS

127 / 163 page

Philips Semiconductors

Product Specification Rev. 3.0; May 2003

Multiple Protocol Contactless Reader IC

CL RC632

127

Confidential

18.5.2.3 Collision Detection

If more than one label is within the RF-field during the label selection phase, they will respond

simultaneously. The CL RC632 supports the algorithm defined in ISO 15693 as well as the I

•CODE1 anti-

collision algorithm to resolve data-collisions of label serial numbers by doing the so-called anti-collision

procedure. The basis for this is the ability to detect bit-collisions.

Bit-collision detection is supported by the used bit-coding scheme, namely the Manchester-coding. If in the

first and second half-bit of a bit a sub-carrier modulation is detected, instead of forwarding a 1 or a 0 a bit

collision will be signalled. To distinguish a 1 or 0-bit from a bit-collision, the CL RC632 uses the setting of

CollLevel. If the amplitude of the half-bit with smaller amplitude is larger than defined by CollLevel, the CL

RC632 indicates a bit-collision.

If a bit-collision is detected, the error flag CollErr is set.

Independent from the detected collision the receiver continues receiving the incoming data stream. In case of

a bit-collision, the decoder forwards 1 at the collision position.

Note: As an exception, if bit ZeroAfterColl is set, all bits received after the first bit-collision are forced to zero,

regardless whether a bit-collision or an unequivocal state has been detected. This feature eases for the

software to carry out the anti-collision procedure defined in ISO 15693.

When the first bit collision in a frame is detected, the bit position of this collision is stored in the CollPos

The collision position follows the table below:

Collision in Bit

Value of CollPos

SOF

LSBit of LSByte

…

MSBit of LSByte

LSBit of second Byte

…

MSBit of second Byte

LSBit of third Byte

…

Table 18-5: Returned Values for Bit Collision Positions

If a collision is detected in the SOF a frame error is reported and no data is forwarded to the FIFO buffer. In

this case the receiver continues to monitor the incoming signal and generates the correct notifications to the

µ-Processor when the ending of the faulty input stream is detected. This helps the µ-Processor to determine

the time when it is allowed next to send anything to the label.

CLRC63201T/0FE 데이터시트(PDF) 127 Page - NXP Semiconductors