PPC405EP datasheet(30/50 Pages) AMCC

30 / 50 page

PPC405EP – PowerPC 405EP Embedded Processor

AMCC

Revision 1.07 – September 10, 2007

Data Sheet

Unused I/Os

Strapping of some pins may be necessary when they are unused. Although the PPC405EP requires only the pull-

up and pull-down terminations as specified in the “Signal Functional Description” on page 31, good design practice

is to terminate all unused inputs or to configure I/Os such that they always drive. If unused, the peripheral, SDRAM,

and PCI buses should be configured and terminated as follows:

•

Peripheral interface—PerAddr03:31, PerData00:15, and all of the control signals are driven by default. Pull

up PerReady.

•

SDRAM—Program SDRAM0_CFG[EMDULR]=1 and SDRAM0_CFG[DCE]=1. This causes the PPC405EP

to actively drive all of the SDRAM address, data, and control signals.

•

PCI—The PCI pull-up requirements given in the Signal Functional Description apply only when the PCI

interface is being used. When the PCI bridge is unused, configure the PCI controller to park on the bus and

actively drive PCIAD31:00, PCIC3:0/BE3:0, and the remaining PCI control signals by doing the following:

- Strap the PPC405EP to disable the internal PCI arbiter.

- Individually pull up PCISErr, PCIPErr, PCITRDY, and PCIStop through 3.3k

Ω resistors to +3.3V.

- Pull up PCIReq1:2 through a 3.3k

Ω resistor to +3.3V.

- Pull down PCIReq0/Gnt through a 1k

Ω resistor to GND.

External Bus Control Signals

All peripheral bus control signals (PerCS0:4, PerR/W, PerWBE0:1, PerOE, PerWE, PerBLast) are set to the high-

impedance state when ExtReset = 0. In addition, as detailed in the PowerPC 405EP Embedded Processor User’s

Manual, the peripheral bus controller can be programmed via EBC0_CFG to float some of these control signals

between transactions. As a result, a pull-up resistor should be added to those control signals where an undriven

state may affect any devices receiving that particular signal.

The following table lists all of the I/O signals provided by the PPC405EP. Please refer to “Signals Listed

Alphabetically” on page 13 for the pin number to which each signal is assigned.

PPC405EP 데이터시트(PDF) 30 Page - Applied Micro Circuits Corporation