FS2101 datasheet(7/48 Pages) HP

7 / 48 page

Introduction

The PCI Active Analysis Probe module provides a complete

interface between any PCI add-in slot and Agilent Logic

Analyzers. The Analysis Probe interface buffers and in state

mode latches and decodes all PCI cycle types and transactions.

The PCI Active Analysis Probe is a passive bus monitor which

does not assert any signals on the PCI bus. The PCI bus signals

are buffered and then terminated with 90k ohm/10pf terminators

so that they are impedance matched to the logic analyzer. Since

the PCI Active Analysis Probe does contains high speed low

skew buffers very little skew is introduced.

The configuration software on the diskette sets up the format

specification menu of the logic analyzer for compatibility with your

PCI bus. When the state configuration file is loaded, an inverse

assembler is also loaded which decodes PCI transactions into

easy to read mnemonics.

This manual is organized to help you quickly find the information

you need.

•

Analyzing the PCI Local Bus chapter introduces you to the

PCI Active Analysis Probe and lists the minimum equipment

required and accessories supplied for PCI bus analysis.

•

The State Analysis chapter explains how to configure the

PCI Active Analysis Probe to perform state analysis on your

PCI bus.

•

The Timing Analysis chapter explains how to configure the

PCI Active Analysis Probe to perform timing analysis on your

PCI bus.

•

The General Information chapter provides some general

information including the operating characteristics for the PCI

Active Analysis Probe module and the cable header pinout.

How to Use This

Manual

FS2101 데이터시트(PDF) 7 Page - Agilent(Hewlett-Packard)