AT80SND1C-ROTIL datasheet(131/210 Pages) ATMEL

131 / 210 page

131

AT8xC51SND1C

4109E–8051–06/03

IDE/ATAPI Interface

The AT8xC51SND1C provides an IDE/ATAPI interface allowing connection of devices

such as CD-ROM reader, CompactFlash cards, Hard Disk Drive, etc. It consists of a 16-

bit data transfer (read or write) between the AT8xC51SND1C and the IDE device.

Description

The IDE interface mode is enabled by setting the EXT16 bit in AUXR (see Figure 29,

page 29). As soon as this bit is set, all MOVX instructions read or write are done in a 16-

bit mode compare to the standard 8-bit mode. P0 carries the low order multiplexed

address and data bus (A7:0, D7:0) while P2 carries the high order multiplexed address

and data bus (A15:8, D15:8). When writing data in IDE mode, the ACC contains D7:0

data (as in 8-bit mode) while DAT16H register (see Table 122) contains D15:8 data.

When reading data in IDE mode, D7:0 data is returned in ACC while D15:8 data is

returned in DAT16H.

Figure 90 shows the IDE read bus cycle while Figure 91 shows the IDE write bus cycle.

For simplicity, these figures depict the bus cycle waveforms in idealized form and do not

provide precise timing information. For IDE bus cycle timing parameters refer to the

Section “AC Characteristics”.

IDE cycle takes 6 CPU clock periods which is equivalent to 12 oscillator clock periods in

standard mode or 6 oscillator clock periods in X2 mode. For further information on X2

mode, refer to the Section “X2 Feature”, page 12.

Slow IDE devices can be accessed by stretching the read and write cycles. This is done

using the M0 bit in AUXR. Setting this bit changes the width of the RD and WR signals

from 3 to 15 CPU clock periods.

Figure 90. IDE Read Waveforms

Notes:

1. RD signal may be stretched using M0 bit in AUXR register.

2. When executing MOVX @Ri instruction, P2 outputs SFR content.

3. When executing MOVX @DPTR instruction, if DPHDIS is set (Page Access Mode),

P2 outputs SFR content instead of DPH.

ALE

RD(1)

DPL or Ri

D7:0

CPU Clock

DPH or P2

(2),(3)

D15:8

AT80SND1C-ROTIL 데이터시트(PDF) 131 Page - ATMEL Corporation