AT80SND1C-ROTIL datasheet(148/210 Pages) ATMEL

148 / 210 page

148

AT8xC51SND1C

4109E–8051–06/03

Slave Mode

The SPI operates in slave mode when the MSTR bit in SPCON is cleared and data has

been loaded in SPDAT.

Figure 114 shows the SPI block diagram in slave mode. In slave mode, before a data

transmission occurs, the SS pin of the slave SPI must be asserted to low level. SS must

remain low until the transmission of the Byte is complete. In the slave SPI module, data

enters the shift register through the MOSI pin under the control of the serial clock pro-

vided by the master SPI module on the SCK input pin. When the master starts a

transmission, the data in the shift register begins shifting out on the MISO pin. The end

of transfer is signaled by SPIF being set.

When the AT8xC51SND1C is the only slave on the bus, it can be useful not to use SS#

pin and get it back to I/O functionality. This is achieved by setting SSDIS bit in SPCON.

This bit has no effect when CPHA is cleared (see Section "SS Management",

page 150).

Figure 114. SPI Slave Mode Block Diagram

Note:

1. MSTR bit in SPCON is cleared to select slave mode.

Bit Rate

The bit rate can be selected from seven predefined bit rates using the SPR2, SPR1 and

SPR0 control bits in SPCON according to Table 131. These bit rates are derived from

the peripheral clock (F

PER) issued from the Clock Controller block as detailed in Section

"Oscillator", page 12.

MISO/P4.2

MOSI/P4.1

SS/P4.3

SPIF

SPSTA.7

CPOL

SPCON.3

CPHA

SPCON.2

8-bit Shift Register

SPDAT WR

SPDAT RD

SCK/P4.2

SSDIS

SPCON.5

Control and Clock Logic

AT80SND1C-ROTIL 데이터시트(PDF) 148 Page - ATMEL Corporation

AT80SND1C-ROTIL 데이터시트(HTML) 148 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL