AT80SND1C-ROTIL datasheet(156/210 Pages) ATMEL

156 / 210 page

156

AT8xC51SND1C

4109E–8051–06/03

Registers

Table 132. SPCON Register

SPCON (S:C3h) – SPI Control Register

Reset Value = 0001 0100b

Note:

1. When the SPI is disabled, SCK outputs high level.

7654

3210

SPR2

SPEN

SSDIS

MSTR

CPOL

CPHA

SPR1

SPR0

Bit

Number

Bit

Mnemonic

Description

7SPR2

SPI Rate Bit 2

Refer to Table 131 for bit rate description.

6SPEN

SPI Enable Bit

Set to enable the SPI interface.

Clear to disable the SPI interface.

5SSDIS

Slave Select Input Disable Bit

Set to disable SS in both master and slave modes. In slave mode this bit has no

effect if CPHA = 0.

Clear to enable SS in both master and slave modes.

4MSTR

Master Mode Select

Set to select the master mode.

Clear to select the slave mode.

3CPOL

SPI Clock Polarity Bit

(1)

Set to have the clock output set to high level in idle state.

Clear to have the clock output set to low level in idle state.

2CPHA

SPI Clock Phase Bit

Set to have the data sampled when the clock returns to idle state (see CPOL).

Clear to have the data sampled when the clock leaves the idle state (see CPOL).

1 - 0

SPR1:0

SPI Rate Bits 0 and 1

Refer to Table 131 for bit rate description.

AT80SND1C-ROTIL 데이터시트(PDF) 156 Page - ATMEL Corporation

AT80SND1C-ROTIL 데이터시트(HTML) 156 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL