HD6432351 datasheet(247/1025 Pages) RENESAS

247 / 1025 page

Section 7 DMA Controller (DMAC)

Rev. 3.00 Sep 15, 2006 page 213 of 988

REJ09B0330-0300

Bit 5—Data Transfer Enable 0B (DTE0B): Enables or disables data transfer on channel 0B.

Bit 5

DTE0B

Description

Data transfer disabled

(Initial value)

Data transfer enabled

Bit 4—Data Transfer Enable 0A (DTE0A): Enables or disables data transfer on channel 0A.

Bit 4

DTE0A

Description

Data transfer disabled

(Initial value)

Data transfer enabled

Bits 3 to 0—Data Transfer End Interrupt Enable (DTIE): These bits enable or disable an

interrupt to the CPU or DTC when transfer ends. If the DTIE bit is set to 1 when DTE = 0, the

DMAC regards this as indicating the end of a transfer, and issues a transfer end interrupt request to

the CPU or DTC.

A transfer end interrupt can be canceled either by clearing the DTIE bit to 0 in the interrupt

handling routine, or by performing processing to continue transfer by setting the transfer counter

and address register again, and then setting the DTE bit to 1.

Bit 3—Data Transfer Interrupt Enable 1B (DTIE1B): Enables or disables the channel 1B

transfer end interrupt.

Bit 3

DTIE1B

Description

Transfer end interrupt disabled

(Initial value)

Transfer end interrupt enabled

Bit 2—Data Transfer Interrupt Enable 1A (DTIE1A): Enables or disables the channel 1A

transfer end interrupt.

Bit 2

DTIE1A

Description

Transfer end interrupt disabled

(Initial value)

Transfer end interrupt enabled

HD6432351 데이터시트(PDF) 247 Page - Renesas Technology Corp