HD6432351 datasheet(258/1025 Pages) RENESAS

258 / 1025 page

Section 7 DMA Controller (DMAC)

Rev. 3.00 Sep 15, 2006 page 224 of 988

REJ09B0330-0300

Bits 10 and 8—Reserved: Can be read or written to.

Bits 7 and 5—Data Transfer Master Enable (DTME): Together with the DTE bit, these bits

control enabling or disabling of data transfer on the relevant channel. When both the DTME bit

and the DTE bit are set to 1, transfer is enabled for the channel.

If the relevant channel is in the middle of a burst mode transfer when an NMI interrupt is

generated, the DTME bit is cleared, the transfer is interrupted, and bus mastership passes to the

CPU. When the DTME bit is subsequently set to 1 again, the interrupted transfer is resumed. In

block transfer mode, however, the DTME bit is not cleared by an NMI interrupt, and transfer is

not interrupted.

The conditions for the DTME bit being cleared to 0 are as follows:

• When initialization is performed

• When NMI is input in burst mode

• When 0 is written to the DTME bit

The condition for DTME being set to 1 is as follows:

• When 1 is written to DTME after DTME is read as 0

Bit 7—Data Transfer Master Enable 1 (DTME1): Enables or disables data transfer on channel

Bit 7

DTME1

Description

Data transfer disabled. In burst mode, cleared to 0 by an NMI interrupt

(Initial value)

Data transfer enabled

Bit 5—Data Transfer Master Enable 0 (DTME0): Enables or disables data transfer on channel

Bit 5

DTME0

Description

Data transfer disabled. In normal mode, cleared to 0 by an NMI interrupt (Initial value)

Data transfer enabled

HD6432351 데이터시트(PDF) 258 Page - Renesas Technology Corp