SH7708 datasheet(171/633 Pages) RENESAS

171 / 633 page

153

8.7

Hardware Standby Mode

The hardware standby mode is provided only in the SH7708S and SH7708R. This mode is not

supported in emulator.

8.7.1

Transition to Hardware Standby Mode

Driving the CA pin low causes a transition to hardware standby mode. In hardware standby mode,

all modules except those operating on an RTC clock are halted, as in the standby mode entered on

execution of a SLEEP instruction.

Hardware standby mode differs from standby mode as follows.

1. Interrupts and manual resets are not accepted.

2. The TCLK clock output is fixed low.

3. The TMU does not operate.

4. In the SH7708S and SH7708R, the RTC continues to operate even if power is not supplied to

power supply pins other than those for RTC power. In this case, all output pins go to the non-

drive state. With the SH7708, it is not possible to supply power only to the RTC power

supply.

Operation when a low-level signal is input at the CA pin depends on the CPG state, as follows.

1. In standby mode

The clock remains stopped and the chip enters the hardware standby state. Acceptance of

interrupts and manual resets is disabled, TCLK output is fixed low, and the TMU halts.

2. During WDT operation when standby mode is canceled by an interrupt

The chip enters hardware standby mode after standby mode is canceled and the CPU resumes

operation.

3. In sleep mode

The chip enters hardware standby mode after sleep mode is canceled and the CPU resumes

operation.

4. During PLL standby (see section 9.6 for the PLL standby function)

The chip enters hardware standby mode after forced implementation of the PLL OFF state.

Hold the CA pin low in hardware standby mode.

SH7708 데이터시트(PDF) 171 Page - Renesas Technology Corp