UM0034 datasheet(13/39 Pages) STMICROELECTRONICS

13 / 39 page

ST7-EMU3 series emulator

Connectivity

13/39

address must be unique on your network. In Figure 14, we have used

164.129.123.244

as the IP address. Press the Enter key on your keyboard.

The Hyperterminal console will indicate that the IP address has been set, and will also

report the submask.

At the prompt type nvsave, and press Enter, to save your configuration (Figure 14).

10. The Hyperterminal console will indicate that your configuration has been saved

11. Exit the Hyperterminal console and disconnect the serial cable between your host PC

and the ST Micro Connect box. Connect it to your network using an Ethernet

connection.

12. Ensure that no application board is connected to your ST Micro Connect box, then

reboot it by switching it off and then on again. When rebooted, your network will

recognize the device by its new IP address.

Figure 11.

Hyperterminal new connection

Figure 12.

Connecting to a COM port

Figure 13.

Configuring the COM port

Figure 14.

Configuration saved

Assign the IP address

Save the configuration

UM0034 데이터시트(PDF) 13 Page - STMicroelectronics