UM0034 datasheet(18/39 Pages) STMICROELECTRONICS

18 / 39 page

Emulation configuration

ST7-EMU3 series emulator

18/39

4.3.2

Probe connection cables

The ST Micro Connect box connects to your EMU3 probe via the two 80-wire flat cables

coming from the front panel. When you receive your emulator, the ST Micro Connect box

and the probe should already be connected (see Figure 19).

Figure 19.

Connecting the 80-pin cables to the EMU3 probe

To disconnect or reconnect the cables, do the following:

To disconnect the probe

Power off your application board and the ST Micro Connect box.

Unplug the long, 80-wire flat cable that is connected to port number 2 on top of the

probe. Grasp the sides of the plug, squeeze to release the two metal locks and pull

upwards, unplugging the cable from the port.

Unplug the short, 80-wire flat cable that is connected to port number 1 in the same

manner.

To reconnect the probe

Plug the 80-wire flat cables back into their ports.

●

The short 80-wire flat cable (bottom) always plugs into port number 1.

●

The long 80-wire flat cable (top) always plugs into port number 2 (see Figure 19).

Upper cable (long)

Lower cable (short)

Micro Connect ports

EMU3 probe

ST Micro Connect box

UM0034 데이터시트(PDF) 18 Page - STMicroelectronics