ATmega1284P datasheet(23/380 Pages) ATMEL

23 / 380 page

8059D–AVR–11/09

ATmega1284P

When the write access time has elapsed, the EEPE bit is cleared by hardware. The user soft-

ware can poll this bit and wait for a zero before writing the next byte. When EEPE has been set,

the CPU is halted for two cycles before the next instruction is executed.

• Bit 0 – EERE: EEPROM Read Enable

The EEPROM Read Enable Signal EERE is the read strobe to the EEPROM. When the correct

address is set up in the EEAR Register, the EERE bit must be written to a logic one to trigger the

EEPROM read. The EEPROM read access takes one instruction, and the requested data is

available immediately. When the EEPROM is read, the CPU is halted for four cycles before the

next instruction is executed.

The user should poll the EEPE bit before starting the read operation. If a write operation is in

progress, it is neither possible to read the EEPROM, nor to change the EEAR Register.

The calibrated Oscillator is used to time the EEPROM accesses. Table 6-2 on page 23 lists the

typical programming time for EEPROM access from the CPU.

Table 6-2.

EEPROM Programming Time

Symbol

Number of Calibrated RC Oscillator Cycles

Typ Programming Time

EEPROM write

(from CPU)

26,368

3.3 ms

ATmega1284P 데이터시트(PDF) 23 Page - ATMEL Corporation