STM32F103CBU6TR datasheet(20/96 Pages) STMICROELECTRONICS

20 / 96 page

Description

STM32F103x8, STM32F103xB

20/96

Doc ID 13587 Rev 12

2.3.21

GPIOs (general-purpose inputs/outputs)

Each of the GPIO pins can be configured by software as output (push-pull or open-drain), as

input (with or without pull-up or pull-down) or as peripheral alternate function. Most of the

GPIO pins are shared with digital or analog alternate functions. All GPIOs are high-current-

capable except for analog inputs.

The I/Os alternate function configuration can be locked if needed following a specific

sequence in order to avoid spurious writing to the I/Os registers.

I/Os on APB2 with up to 18 MHz toggling speed

2.3.22

ADC (analog-to-digital converter)

Two 12-bit analog-to-digital converters are embedded into STM32F103xx performance line

devices and each ADC shares up to 16 external channels, performing conversions in single-

shot or scan modes. In scan mode, automatic conversion is performed on a selected group

of analog inputs.

Additional logic functions embedded in the ADC interface allow:

●

Simultaneous sample and hold

●

Interleaved sample and hold

●

Single shunt

The ADC can be served by the DMA controller.

An analog watchdog feature allows very precise monitoring of the converted voltage of one,

some or all selected channels. An interrupt is generated when the converted voltage is

outside the programmed thresholds.

The events generated by the general-purpose timers (TIMx) and the advanced-control timer

(TIM1) can be internally connected to the ADC start trigger, injection trigger, and DMA

trigger respectively, to allow the application to synchronize A/D conversion and timers.

2.3.23

Temperature sensor

The temperature sensor has to generate a voltage that varies linearly with temperature. The

conversion range is between 2 V < VDDA < 3.6 V. The temperature sensor is internally

connected to the ADC12_IN16 input channel which is used to convert the sensor output

voltage into a digital value.

2.3.24

Serial wire JTAG debug port (SWJ-DP)

The ARM SWJ-DP Interface is embedded. and is a combined JTAG and serial wire debug

port that enables either a serial wire debug or a JTAG probe to be connected to the target.

The JTAG TMS and TCK pins are shared with SWDIO and SWCLK, respectively, and a

specific sequence on the TMS pin is used to switch between JTAG-DP and SW-DP.

STM32F103CBU6TR 데이터시트(PDF) 20 Page - STMicroelectronics

STM32F103CBU6TR 데이터시트(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96

데이터시트 다운로드

링크 URL