LPC4350 datasheet(75/145 Pages) NXP

75 / 145 page

LPC4350_30_20_10

All information provided in this document is subject to legal disclaimers.

Objective data sheet

Rev. 2.1 — 23 September 2011

75 of 145

NXP Semiconductors

LPC4350/30/20/10

32-bit ARM Cortex-M4/M0 microcontroller

• Internal four-word FIFO per channel.

• Supports 8, 16, and 32-bit wide transactions.

• Big-endian and little-endian support. The DMA Controller defaults to little-endian

mode on reset.

• An interrupt to the processor can be generated on a DMA completion or when a DMA

error has occurred.

• Raw interrupt status. The DMA error and DMA count raw interrupt status can be read

prior to masking.

7.17.2 SPI Flash Interface (SPIFI)

The SPI Flash Interface allows low-cost serial flash memories to be connected to the ARM

Cortex-M4 processor with little performance penalty compared to parallel flash devices

with higher pin count.

After a few commands configure the interface at startup, the entire flash content is

accessible as normal memory using byte, halfword, and word accesses by the processor

and/or DMA channels. Erasure and programming are handled by simple sequences of

commands.

Many serial flash devices use a half-duplex command-driven SPI protocol for device setup

and initialization and then move to a half-duplex, command-driven 4-bit protocol for

normal operation. Different serial flash vendors and devices accept or require different

commands and command formats. SPIFI provides sufficient flexibility to be compatible

with common flash devices and includes extensions to help insure compatibility with future

devices.

7.17.2.1

Features

• Interfaces to serial flash memory in the main memory map.

• Supports classic and 4-bit bidirectional serial protocols.

• Half-duplex protocol compatible with various vendors and devices.

• Data rates of up to 40 MB per second.

• Supports DMA access.

7.17.3 SD/MMC card interface

The SD/MMC card interface supports the following modes to control:

• Secure Digital memory (SD version 3.0)

• Secure Digital I/O (SDIO version 2.0)

• Consumer Electronics Advanced Transport Architecture (CE-ATA version 1.1)

• MultiMedia Cards (MMC version 4.4)

7.17.4 External Memory Controller (EMC)

The LPC4350/30/20/10 EMC is a Memory Controller peripheral offering support for

asynchronous static memory devices such as RAM, ROM, and flash. In addition, it can be

used as an interface with off-chip memory-mapped devices and peripherals.

LPC4350 데이터시트(PDF) 75 Page - NXP Semiconductors

LPC4350 데이터시트(HTML) 75 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL