S29GL01GP datasheet(77/81 Pages) SPANSION

77 / 81 page

October 22, 2012 S29GL-P_00_A14

S29GL-P MirrorBit® Flash Family

Data

She e t

Figure 13.2 Warm Reset Timing

Note:

The sum of tRP and tRH must be equal to or greater than tRPH.

The differences in power-on timing should not present a migration challenge for most applications where the

flash interfaces directly with a Host that requires oscillator and PLL lock prior to initiating the first boot read

access to the flash. In applications which may access the flash within 300 µs of power application, some

circuit modification will be required to accommodate migration to GL-S flash.

To initiate the first read or write cycle after power on, the GL-S requires CE# or OE# to transition from High to

Low no sooner than tVCS after VCC exceeds VCC_min and VIO exceeds VIO_min. CE# or OE# must be High at

least tCEH = 20 ns prior to CE# or OE# falling edge which initiates the first access.

CE# is ignored during Warm Reset; however, to initiate the first read or write cycle after warm reset, the GL-S

requires CE# to transition from High to Low no sooner than tRH after RESET# transitions from Low to High.

CE# must be high at least tCEH = 20 ns prior to CE# falling edge, which initiates first access. These were not

requirements for the GL-P so designs that have CE# fixed low cannot migrate to GL-S without modification to

enable active CE# control.

The GL-S allows VIO to ramp concurrently with or after VCC with no restriction on time or voltage differential.

During power ramp no input is allowed to exceed VIO. The GL-S data sheet provides enhanced direction on

power management and control to design a robust and reliable system.

S29GL01GP 데이터시트(PDF) 77 Page - SPANSION