CDCM7005_13 datasheet(26/45 Pages) TI

26 / 45 page

T0064-01

(lockdetect)

SelectedREFatPFD

(clockfedthroughMDividerandMDelay)

VCXO_INatPFD

(clockfedthroughNDividerandNDelay)

T0063-01

PRI_REF

SEC_REF

Internal

ReferenceClock

YxOutput

PRI_SEC_CLK

PrimaryClock

SecondaryClock

PrimaryClock

CDCM7005

SCAS793E – JUNE 2005 – REVISED FEBRUARY 2013

www.ti.com

Figure 16. Phase Approach of Output to New Reference Clock

PLL Lock for Analog and Digital Detect

The CDCM7005 supports two PLL lock indications: the digital lock signal or the analog lock signal. Both signals

indicate logic high-level at PLL_LOCK if the PLL locks according the selected lock condition.

PLL Lock/Out-of-Lock Definition

The PLL is locked (set high), if the rising edge of the Reference Clock (PRI_REF or SEC_REF clock) and

Feedback Clock (VCXO_IN clock) at the PFD (phase frequency detect) are inside a predefined lock detect

window, or if no frequency offset appears, for a pre-defined number of successive clock cycles.

The PLL is out-of-lock (set low), if the rising edge of the Reference Clock (PRI_REF or SEC_REF clock) and

Feedback Clock (VCXO_IN clock) at the PFD are outside the predefined lock detect window or if a frequency

offset appears.

Both, the lock detect window and the number of successive clock cycles are user definable (Word 3, Bit 2-6).

Figure 17. Lock Detect Window

The lock detect window describes the maximum allowed time difference for lock detect between the rising edge

of PRI_REF or SEC_REF and VCXO_IN. The time difference is detected at the phase frequency detector. The

rising edge of PRI_REF or SEC_REF is taken as reference. The rising edge of VCXO_IN is outside the lock

detect window if there is a phase displacement of more than +0.5 × t(lockdetect) or -0.5 x t(lockdetect).

Submit Documentation Feedback

Product Folder Links :CDCM7005

CDCM7005 데이터시트(PDF) 26 Page - Texas Instruments