JS28F256P33BFE datasheet(35/90 Pages) MICRON

35 / 90 page

Datasheet

Aug 2009

Order Number:320003-08

P33-65nm

11.1.1

Read Mode

The Read Mode (RM) bit selects synchronous burst-mode or asynchronous page-mode

operation for the device. When the RM bit is set, asynchronous page mode is selected

(default). When RM is cleared, synchronous burst mode is selected.

11.1.2

Latency Count

The Latency Count (LC) bits tell the device how many clock cycles must elapse from the

rising edge of ADV# (or from the first valid clock edge after ADV# is asserted) until the

first valid data word is driven onto DQ[15:0]. The input clock frequency is used to

determine this value and Figure 9 shows the data output latency for the different

settings of LC. The maximum Latency Count for P33 would be Code 4 based on the Max

clock frequency specification of 52 MHz, and there will be zero WAIT States when

bursting within the word line. Please also refer to Section 11.1.3, “End of Word Line

(EOWL) Considerations” on page 37 for more information on EOWL.

Refer to Table 12, “LC and Frequency Support” on page 36 for Latency Code Settings.

Burst Wrap (BW)

0 =Wrap; Burst accesses wrap within burst length set by BL[2:0]

1 =No Wrap; Burst accesses do not wrap within burst length (default)

2:0

Burst Length (BL[2:0])

001 =4-word burst

010 =8-word burst

011 =16-word burst

111 =Continuous-word burst (default)

(Other bit settings are reserved)

Table 11: Read Configuration Register Description (Sheet 2 of 2)

JS28F256P33BFE 데이터시트(PDF) 35 Page - Micron Technology