DOC7707 datasheet(254/307 Pages) ETC1

254 / 307 page

254

7707F–AVR–11/10

AT90USB82/162

Figure 25-5. Programming the FUSES Waveforms

25.6.11

Programming the Lock Bits

The algorithm for programming the Lock bits is as follows (refer to “Programming the Flash” on

page 249 for details on Command and Data loading):

A: Load Command “0010 0000”.

C: Load Data Low Byte. Bit n = “0” programs the Lock bit. If LB mode 3 is programmed

(LB1 and LB2 is programmed), it is not possible to program the Boot Lock bits by any

External Programming mode.

Give WR a negative pulse and wait for RDY/BSY to go high.

The Lock bits can only be cleared by executing Chip Erase.

25.6.12

Reading the Fuse and Lock Bits

The algorithm for reading the Fuse and Lock bits is as follows (refer to “Programming the Flash”

on page 249 for details on Command loading):

A: Load Command “0000 0100”.

Set OE to “0”, and BS2, BS1 to “00”. The status of the Fuse Low bits can now be read

at DATA (“0” means programmed).

Set OE to “0”, and BS2, BS1 to “11”. The status of the Fuse High bits can now be read

at DATA (“0” means programmed).

Set OE to “0”, and BS2, BS1 to “10”. The status of the Extended Fuse bits can now be

read at DATA (“0” means programmed).

Set OE to “0”, and BS2, BS1 to “01”. The status of the Lock bits can now be read at

DATA (“0” means programmed).

Set OE to “1”.

RDY/BSY

RESET +12V

PAGEL

0x40

DATA

XA1

XA0

BS1

XTAL1

0x40

DATA

Write Fuse Low byte

Write Fuse high byte

0x40

DATA

Write Extended Fuse byte

BS2

DOC7707 데이터시트(PDF) 254 Page - List of Unclassifed Manufacturers

DOC7707 데이터시트(HTML) 254 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL