DOC7707 datasheet(80/307 Pages) ETC1

80 / 307 page

7707F–AVR–11/10

AT90USB82/162

TXD1, USART1 Transmit Data : When the USART1 Transmitter is enabled, this pin is config-

ured as an ouput regardless of DDRD3.

• INT2/AIN1/RXD1, Bit 2

INT2, External Interrupt source 2: The PD2 pin can serve as an external interrupt source to the

MCU.

AIN1, Analog Comparator Negative input. This pin is directly connected to the negative input of

the Analog Comparator.

RXD1, USART1 Receive Data : When the USART1 Receiver is enabled, this pin is configured

as an input regardless of DDRD2. When the USART forces this pin to be an input, the pull-up

can still be controlled by the PORTD2 bit.

• INT1/AIN0, Bit 1

INT1, External Interrupt source 1: The PD1 pin can serve as an external interrupt source to the

MCU.

AIN0, Analog Comparator Positive input. This pin is directly connected to the positive input of

the Analog Comparator.

• INT0/OC0B, Bit 0

INT0, External Interrupt source 0: The PD0 pin can serve as an external interrupt source to the

MCU.

OC0B, Output Compare Match B output: The PD0 pin can serve as an external output for the

Timer/Counter0 Output Compare. The pin has to be configured as an output (DDD0 set “one”) to

serve this function. The OC0B pin is also the output pin for the PWM mode timer function.

Table 11-10 and Table 11-11 relates the alternate functions of Port D to the overriding signals

shown in Figure 11-5 on page 72.

DOC7707 데이터시트(PDF) 80 Page - List of Unclassifed Manufacturers