AD-DPGIOZ datasheet(18/61 Pages) AD

18 / 61 page

AD9961/AD9963

Data Sheet

Rev. A | Page 18 of 60

TERMINOLOGY

Linearity Error (Integral Nonlinearity or INL)

Linearity error is defined as the maximum deviation of the

actual analog output from the ideal output, determined by a

straight line drawn from zero scale to full scale.

Differential Nonlinearity (DNL)

DNL is the measure of the variation in analog value, normalized

to full scale, associated with a 1 LSB change in digital input code.

Monotonicity

A DAC is monotonic if the output either increases or remains

constant as the digital input increases.

Offset Error

The deviation of the output current from the ideal of zero is

called offset error. For TXIN, 0 mA output is expected when the

inputs are all 0s. For TXIP, 0 mA output is expected when all

inputs are set to 1.

Gain Error

The difference between the actual and ideal output span. The

actual span is determined by the difference between the output

when all inputs are set to 1 and the output when all inputs are

set to 0.

Output Compliance Range

The range of allowable voltage at the output of a current-output

DAC. Operation beyond the maximum compliance limits can

cause either output stage saturation or breakdown, resulting in

nonlinear performance.

Temperature Drift

Temperature drift is specified as the maximum change from the

ambient (25°C) value to the value at either TMIN or TMAX. For

offset and gain drift, the drift is reported in parts per million of

full-scale range (FSR) per degree Celsius (°C). For reference

drift, the drift is reported in parts per ppm/°C.

Power Supply Rejection

The maximum change in the full-scale output as the supplies

are varied from minimum to maximum specified voltages.

Settling Time

The time required for the output to reach and remain within a

specified error band around its final value, measured from the

start of the output transition.

Spurious Free Dynamic Range (SFDR)

The difference, in decibels, between the peak amplitude of the

output signal and the peak spurious signal between dc and the

frequency equal to half the input data rate.

Total Harmonic Distortion (THD)

THD is the ratio of the rms sum of the first six harmonic com-

ponents to the rms value of the measured fundamental. It is

expressed as a percentage or in decibels.

Signal-to-Noise Ratio (SNR)

SNR is the ratio of the rms value of the measured output signal

to the rms sum of all other spectral components below the

Nyquist frequency, excluding the first six harmonics and dc.

The value for SNR is expressed in decibels.

Adjacent Channel Leakage Ratio (ACLR)

The ratio in dBc between the measured power within a channel

relative to its adjacent channel.

Complex Image Rejection

In a traditional two-part upconversion, two images are created

around the second IF frequency. These images have the effect of

wasting transmitter power and system bandwidth. By placing

the real part of a second complex modulator in series with the

first complex modulator, either the upper or lower frequency

image near the second IF can be rejected.

AD-DPGIOZ 데이터시트(PDF) 18 Page - Analog Devices

AD-DPGIOZ 데이터시트(HTML) 18 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61

데이터시트 다운로드

링크 URL