L6717 datasheet(36/56 Pages) STMICROELECTRONICS

36 / 56 page

Output voltage positioning

L6717

36/56

Doc ID 17326 Rev 1

Figure 10.

Current reading

The current read through the CSxP / CSxN pairs is converted into a current IINFOx propor-

tional to the current delivered by each phase and the information about the average current

IAVG = ΣIINFOx / N is internally built into the device (N is the number of working phases). The

error between the read current IINFOx and the reference IAVG is then converted into a voltage

that with a proper gain is used to adjust the duty cycle whose dominant value is set by the

voltage error amplifier in order to equalize the current carried by each phase.

7.3

CORE section - defining load-line

L6717 introduces a dependence of the output voltage on the load current recovering part of

the drop due to the output capacitor ESR in the load transient. Introducing a dependence of

the output voltage on the load current, a static error, proportional to the output current,

causes the output voltage to vary according to the sensed current.

Figure 10 shows the current sense circuit used to implement the load-line. The current flow-

ing across the inductor(s) is read through the R - C filter across CSxP and CSxN pins. RG

programs a trans-conductance gain and generates a current ICSx proportional to the current

of the phase. The sum of the ICSx current, with proper gain defined by the DRP_ADJ com-

mand (kDRP), is then sourced by the FB pin (kDRPIDROOP). RFB gives the final gain to pro-

gram the desired load-line slope (Figure 9).

Time constant matching between the inductor (L / DCR) and the current reading filter (RC)

is required to implement a real equivalent output impedance of the system so avoiding over

and/or under shoot of the output voltage as a consequence of a load transient. See

Section 7.2. The output characteristic vs. load current is then given by:

Where RLL is the resulting load-line resistance implemented by the CORE Section. kDRP

value is determined by the Power Manager I2C and its default value is 1/4.

RFB resistor can be then designed according to the RLL specifications and DRP_ADJ setting

as follow:

See Section 6.2 for details about DRP_ADJ command.

CSxP

CSxN

DCRx

PHASEx

Inductor DCR Current Sense

ICSxN=IINFOx

OUT

CORE

VID

DRP

DROOP

⋅⋅

–

VID

DRP

DCR

------------- I

OUT

⋅⋅

⋅

–

VID

OUT

⋅

–

DRP

-------------

DCR

-------------

⋅

L6717 데이터시트(PDF) 36 Page - STMicroelectronics

L6717 데이터시트(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

데이터시트 다운로드

링크 URL