NG80960JS25 datasheet(79/86 Pages) INTEL

79 / 86 page

80960JA/JF/JD/JS/JC/JT 3.3 V Embedded 32-Bit Microprocessor

Datasheet

7.1

Basic Bus States

The bus has five basic bus states: idle (Ti), address (Ta), wait/data (Tw/Td), recovery (Tr), and hold

(Th). During system operation, the processor continuously enters and exits different bus states.

Figure 52 shows the five bus states.

The bus occupies the idle (Ti) state when no address/data transactions are in progress and when

RESET# is asserted. When the processor needs to initiate a bus access, it enters the Ta state to

transmit the address.

Following a Ta state, the bus enters the Tw/Td state to transmit or receive data on the address/data

lines. Assertion of the RDYRCV# input signal indicates completion of each transfer. When data is

not ready, the processor may wait as long as necessary for the memory or I/O device to respond.

After the data transfer, the bus exits the Tw/Td state and enters the recovery (Tr) state. In the case

of a burst transaction, the bus exits the Td state and re-enters the Td/Tw state to transfer the next

data word. The processor asserts the BLAST# signal during the last Tw/Td states of an access.

Once all data words transfer in a burst access (up to four), the bus enters the Tr state to allow

devices on the bus to recover.

The processor remains in the Tr state until RDYRCV# is deasserted. When the recovery state

completes, the bus enters the Ti state when no new accesses are required. When an access is

pending, the bus enters the Ta state to transmit the new address.

NG80960JS25 데이터시트(PDF) 79 Page - Intel Corporation