UPD78323LP datasheet(48/86 Pages) NEC

48 / 86 page

µPD78323, 78324

OPERATION AFTER RESET

If the RESET input pin is set to the low level, the system reset is applied and each hardware becomes as initialized status

(reset status). If RESET input becomes high level, program execution is started. Initialize the contents of various registers

in the program as required.

Change the number of cycles for the programmable wait register and the fetch cycle control register in particular.

The RESET input pin is equipped with an analog delay noise suppressor to prevent malfunctioning due to noise.

Cautions 1. While RESET is active(low level), all pins remain high impedance (except WDTO, AVREF, AVDD, AVSS,

VDD, VSS, X1 and X2).

2. If RAM has been expanded externally, mount a pull-up resistor to the P90/RD and P91/WR pins. It is

possible that the P90/RD and P91/WR pins become high impedance resulting in an external RAM

contents corruption or input unit damage. In addition, signals may collide on the address/data bus,

resulting in the destruction of the input/output circuit.

Figure 7-1. Reset Signal Acknowledge

For reset operation upon power-up, secure the oscillation stabilizing time of about 40 msec from power-up to reset

acknowledge as shown in Figure 7-2.

Figure 7-2. Reset Upon Power-Up

RESET Input

Analog

Delay

Removed

as Noise

Analog

Delay

Reset

Acknowl-

edged

Analog

Delay

Reset

Release

Oscillation

Stabilizing

Time

Analog

Delay

Reset

Release

VDD

RESET

UPD78323LP 데이터시트(PDF) 48 Page - NEC