FXLS8471Q datasheet(41/75 Pages) FREESCALE

41 / 75 page

FXLS8471Q

Sensors

Freescale Semiconductor, Inc.

10.3

Output data registers

10.3.1

OUT_X_MSB (0x01), OUT_X_LSB (0x02), OUT_Y_MSB (0x03), OUT_Y_LSB (0x04),

OUT_Z_MSB (0x05), OUT_Z_LSB (0x06) registers

These registers contain the X-axis, Y-axis, and Z-axis 14-bit left-justified sample data expressed as 2's complement numbers.

The sample data output registers store the current sample data if the FIFO buffer function is disabled, but if the FIFO buffer

function is enabled the sample data output registers then point to the head of the FIFO buffer which contains up to the previous

32 X, Y, and Z data samples.

The data is read out in the following order: Xmsb, Xlsb, Ymsb, Ylsb, Zmsb, Zlsb for CTRL_REG1[f_read] = 0, and Xmsb, Ymsb,

Zmsb for CTRL_REG1[f_read] = 1. Similarly, for CTRL_REG1[f_read] = 1, only the MSB's of the acceleration data are read out

in the same axis order.

If the CTRL_REG1[f_read] bit is set, auto-increment will skip over the LSB registers. This will shorten the data acquisition from

6 bytes to 3 bytes. If the LSB registers are directly addressed, the LSB information can still be read regardless of the

CTRL_REG1[f_read] register setting.

If the FIFO data output register driver is enabled (F_SETUP[f_mode] > 00), register 0x01 points to the head of the FIFO buffer,

while registers 0x02, 0x03, 0x04, 0x05, 0x06 return a value of zero when read directly.

The DR_STATUS registers, OUT_X_MSB, OUT_X_LSB, OUT_Y_MSB, OUT_Y_LSB, OUT_Z_MSB, and OUT_Z_LSB are

located in the auto-incrementing address range of 0x00 to 0x06, allowing all of the acceleration data to be read in a single-burst

FXLS8471Q 데이터시트(PDF) 41 Page - Freescale Semiconductor, Inc