FXLS8471Q datasheet(12/75 Pages) FREESCALE

12 / 75 page

FXLS8471Q

Sensors

Freescale Semiconductor, Inc.

Terminology

4.1

Sensitivity

The sensitivity is represented in LSB/g. In 2-g mode the sensitivity is 4096 LSB/g. In 4-g mode the sensitivity is 2048 LSB/ g and

in 8-g mode the sensitivity is 1024 LSB/g.

4.2

Zero-g Offset

Zero-g Offset describes the deviation of an actual output signal from the ideal output signal if the sensor is stationary. A sensor

stationary on a horizontal surface will measure 0 g in X-axis and 0 g in Y-axis whereas the Z-axis will measure 1 g. A deviation from

ideal value in this case is called Zero-g offset. Offset is to some extent a result of stress on the MEMS sensor and therefore the

offset can slightly change after mounting the sensor onto a printed circuit board or exposing it to extensive mechanical stress.

4.3

Self-Test

Self-Test can be used to verify the transducer functionality without applying an external mechanical stimulus. When Self-Test is

activated, an electrostatic actuation force is applied to the sensor, simulating a small acceleration. In this case, the sensor outputs

will exhibit a change in their DC levels which are related to the selected full scale through the device sensitivity. When Self-Test is

activated, the device output level is given by the algebraic sum of the signals produced by the acceleration acting on the sensor

and by the electrostatic self-test force.

FXLS8471Q 데이터시트(PDF) 12 Page - Freescale Semiconductor, Inc