M38B53M4-059FP datasheet(325/355 Pages) MITSUBISHI

325 / 355 page

38B5 Group User’s Manual

3-77

APPENDIX

3.8 Mark specification form

Mitsubishi product number

(6-digit, or 7-digit)

Customer’s Par ts Number

Note

: The fonts and size of characters are standard Mitsubishi type.

Mitsubishi IC catalog name

Notes 1 : The mark field should be written right aligned.

2 : The fonts and size of characters are standard Mitsubishi type.

3 : Customer’s parts number can be up to 14 alphanumeric char-

acters for capital letters, hyphens, commas, periods and so on.

4 : If the Mitsubishi logo

is not required, check the box below.

Mitsubishi logo is not required

80P6N (80-PIN QFP) MARK SPECIFICATION FORM

Mitsubishi IC catalog name

Please choose one of the marking types below (A, B, C), and enter the Mitsubishi IC catalog name and the special mark (if needed).

A. Standard Mitsubishi Mark

C. Special Mark Required

B. Customer’s Parts Number + Mitsubishi IC Catalog Name

Mitsubishi IC catalog name

Notes1 : If special mark is to be printed, indicate the desired lay-

out of the mark in the left figure. The layout will be

duplicated technically as close as possible.

Mitsubishi product number (6-digit, or 7-digit) and Mask

ROM number (3-digit) are always marked for sorting the

products.

2 : If special character fonts (e,g., customer’s trade mark

logo) must be used in Special Mark, check the box be-

low.

For the new special character fonts, a clean font original

(ideally logo drawing) must be submitted.

Special character fonts required

M38B53M4-059FP 데이터시트(PDF) 325 Page - Mitsubishi Electric Semiconductor