M38B53M4-059FP datasheet(267/355 Pages) MITSUBISHI

267 / 355 page

38B5 Group User’s Manual

3-19

APPENDIX

3.3 Notes on use

3.3.4 Notes on FLD controller

q Set a value of 0316 or more to the Toff1 time set register.

q When displaying in the gradation display mode, select the 16 timing mode by the timing number control

bit (bit 4 of FLDC mode register (address 0EF416) = “0”).

3.3.5 Notes on A-D converter

(1)

Analog input pin

s Make the signal source impedance for analog input low, or equip an analog input pin with an

external capacitor of 0.01

µF to 1 µF. Further, be sure to verify the operation of application

products on the user side.

q Reason

An analog input pin includes the capacitor for analog voltage comparison. Accordingly, when

signals from signal source with high impedance are input to an analog input pin, charge and

discharge noise generates. This may cause the A-D conversion precision to be worse.

s When the P64/INT4/SBUSY1/AN10 pin is selected as analog input pin, external interrupt function (INT4)

becomes invalid.

(2)

A-D converter power source pin

The AVSS pin is A-D converter power source pin. Regardless of using the A-D conversion function

or not, connect it as following :

• AVSS : Connect to the VSS line

q Reason

If the AVSS pin is opened, the microcomputer may have a failure because of noise or others.

(3)

Clock frequency during A-D conversion

The comparator consists of a capacity coupling, and a charge of the capacity will be lost if the clock

frequency is too low. Thus, make sure the following during an A-D conversion.

• f(XIN) is 250 kHz or more

• Use clock divided by main clock (f(XIN)) as internal system clock.

• Do not execute the STP instruction and WIT instruction

3.3.6 Notes on PWM

q For PWM0 output, “L” level is output first.

q After data is set to the PWM register (low-order) and the PWM register (high-order), PWM waveform

corresponding to new data is output from next repetitive cycle.

Fig. 3.3.5 PWM output

PWM0 output data

change

Modified data is output from next

repetitive cycle.

M38B53M4-059FP 데이터시트(PDF) 267 Page - Mitsubishi Electric Semiconductor

M38B53M4-059FP 데이터시트(HTML) 267 Page - Mitsubishi Electric Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL