STM32F446VC datasheet(38/202 Pages) STMICROELECTRONICS

38 / 202 page

Functional overview

STM32F446xC/E

38/202

DocID027107 Rev 6

The major features are:

•

Combined Rx and Tx FIFO size of 1 Kbit × 35 with dynamic FIFO sizing

•

Supports the session request protocol (SRP) and host negotiation protocol (HNP)

•

8 bidirectional endpoints

•

16 host channels with periodic OUT support

•

Internal FS OTG PHY support

•

External HS or HS OTG operation supporting ULPI in SDR mode. The OTG PHY is

connected to the microcontroller ULPI port through 12 signals. It can be clocked using

the 60 MHz output.

•

Internal USB DMA

•

HNP/SNP/IP inside (no need for any external resistor)

•

for OTG/Host modes, a power switch is needed in case bus-powered devices are

connected

3.35

Digital camera interface (DCMI)

The devices embed a camera interface that can connect with camera modules and CMOS

sensors through an 8-bit to 14-bit parallel interface, to receive video data. The camera

interface can sustain a data transfer rate up to 94.5 Mbyte/s (in 14-bit mode) at 54 MHz.

Its features:

•

Programmable polarity for the input pixel clock and synchronization signals

•

Parallel data communication can be 8-, 10-, 12- or 14-bit

•

Supports 8-bit progressive video monochrome or raw bayer format, YCbCr 4:2:2

progressive video, RGB 565 progressive video or compressed data (like JPEG)

•

Supports continuous mode or snapshot (a single frame) mode

•

Capability to automatically crop the image black & white.

3.36

General-purpose input/outputs (GPIOs)

Each of the GPIO pins can be configured by software as output (push-pull or open-drain,

with or without pull-up or pull-down), as input (floating, with or without pull-up or pull-down)

or as peripheral alternate function. Most of the GPIO pins are shared with digital or analog

alternate functions. All GPIOs are high-current-capable and have speed selection to better

manage internal noise, power consumption and electromagnetic emission.

The I/O configuration can be locked if needed by following a specific sequence in order to

avoid spurious writing to the I/Os registers.

Fast I/O handling allowing maximum I/O toggling up to 90 MHz.

3.37

Analog-to-digital converters (ADCs)

Three 12-bit analog-to-digital converters are embedded and each ADC shares up to 16

external channels, performing conversions in the single-shot or scan mode. In scan mode,

automatic conversion is performed on a selected group of analog inputs.

STM32F446VC 데이터시트(PDF) 38 Page - STMicroelectronics

STM32F446VC 데이터시트(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL