UCS1001-3 datasheet(47/57 Pages) MICROCHIP

47 / 57 page

USB Port Power Controller with Charger Emulation

Datasheet

SMSC UCS1001

Revision 1.4 (07-16-13)

DATASHEET

8.10

Preloaded Charger Emulation Profiles

The following charger emulation profiles are resident to the UCS1001:

1. Legacy 1 - See Section 8.10.1

2. Legacy 2, 4, 5, and 7 - See Section 8.10.2

3. Legacy 3 - See Section 8.10.3

4. Legacy 6 - See Section 8.10.4

5. BC1.2 CDP - See Section 8.6.1

6. BC1.2 DCP - See Section 8.7.1

8.10.1

Legacy 1 Charger Emulation Profile

Legacy 1 charger emulation profile does the following:

1. The UCS1001 will apply 900 mV to both the DPOUT and the DMOUT pins.

2. VBUS voltage is applied.

3. If the portable device is charging, the UCS1001 will accept that the currently applied profile is the

correct charger emulation profile for the attached portable device. The voltages applied to the

DPOUT and DMOUT pins will remain in place. The UCS1001 will begin operating in trip mode

4. If the portable device is not charging, the UCS1001 will stop the currently applied charger emulation

profile. This will cause all voltages put onto the DPOUT and DMOUT pins to be removed. Emulation

reset occurs, and the UCS1001 will initiate the next charger emulation profile.

8.10.2

Legacy 2, 4, 5, and 7 Charger Emulation Profiles

Legacy 2, 4, 5, and 7 charger emulation profiles follow the same pattern of operation although the

voltage that is applied on the DPOUT and DMOUT pins will vary. They do the following:

1. The UCS1001 will apply a voltage on the DPOUT pin using either a current-limited voltage source

or a voltage divider between VBUS and ground with the center tap on the DPOUT pin.

2. The UCS1001 will apply a possibly different voltage on the DMOUT pin using either a current-

limited voltage source or a voltage divider between VBUS and ground with the center tap on the

DMOUT pin.

3. VBUS voltage is applied.

DCE CYCLE

During DCE Cycle when a charger

emulation profile is being applied

CC mode if ILIM < 1.5 A, otherwise, trip mode

Legacy 2 charger emulation profile

accepted

CC mode if ILIM < 1.5 A, otherwise, trip mode

Legacy 1 or Legacy 3 - Legacy 7 charger

emulation profile accepted

Trip mode

Table 8.2 Current Limit Mode Options (continued)

ACTIVE MODE

CURRENT LIMIT MODE

UCS1001-3 데이터시트(PDF) 47 Page - Microchip Technology

UCS1001-3 데이터시트(HTML) 47 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

데이터시트 다운로드

링크 URL